Kel-Tec Support

The video above describes the conversion of your 6 round Ruger LCP or Kel-Tec P3at magazine to 7 rounds using the latest hybrid spring system.

OLDER VERSION INSTRUCTIONS

The following video and instructions are for prior MagGuts versions that have been replaced with newer versions. Follow these only if you are using the older version conversions as the assembly orientation is different from the current versions.

The video above describes the conversion of your 6 round Ruger LCP or Kel-Tec P3at magazine to 7 rounds. This video is for the conversions that use the split followers and the original dual wire spring system. If you are using the newer hybrid spring system or the original flat follower, refer to the appropriate video for conversion instructions as the assembly is different.

Ruger LCP Kel-Tec P3AT

These instructions are for converting the Ruger LCP and Kel-Tec P3AT magazines from 6 to 7 rounds using the split follower and dual wire spring version of the MagGuts system.

This video is for instructions on how to install the MagGuts Spring System using the original flat follower to upgrade your Ruger LCP, Kel-Tec P3AT magazines from 6 to 7 round capacity. Orders placed before February 16, 2013 for the Ruger LCP or Kel-Tec P3AT MagGuts conversions have the original flat followers and should use this video for conversion instruction. Newer conversions using the ‘split’ followers see above video.

Ruger Kel-Tec Instructions

These instructions are for the original flat follower version. If you are converting your magazine using the newer split follower, use the appropriate instructions shown elsewhere on this page.

Copyright © 2024 MagGuts. All rights reserved.